Fabricator: Zyvex Pharmaceuticals
Unit: x1 10 ml
Strength: 250 mg/ml
If your order hasn’t arrived within 35 days after shipping, we’ll resend it for free.
Sustanon is not a compound, it is a delivery design. Four testosterone esters sit in the same millilitre, each releasing at a different speed, so a single injection produces a sharp early rise and a level that is still present a fortnight later. It was built for hormone replacement, where the point was fewer injections rather than better pharmacology.
Zyvex supplies it at 250 mg per millilitre in a multi-dose vial, batch coded on the label. Everything it does is testosterone, delivered on a curve.
The blend is propionate, phenylpropionate, isocaproate and decanoate, roughly thirty, sixty, sixty and one hundred milligrams in a millilitre. The propionate lands within a day, the decanoate carries for weeks, and the two middle esters fill the gap between them.
That design has a consequence worth understanding: the level keeps climbing for the first fortnight rather than settling, because the long ester accumulates while the short ones spike. Judging the dose at day ten is premature, and the eventual plateau is higher than the early numbers suggest.
Each millilitre contains 250 mg of mixed testosterone esters in a pharmaceutical oil carrier with standard preservative agents. The exact ester breakdown and excipient panel are printed on the Zyvex label, since blends vary between manufacturers and the proportions matter to the release curve.
Twice a week on a cycle, splitting the weekly total so the propionate peak is not concentrated in one shot. For replacement, weekly or every ten days is enough because of the decanoate tail. Keep the vial upright at room temperature and rotate sites.
Four esters climb at different rates, so week four is the earliest point at which a judgement about dose means anything. Oestrogen tracks the total weekly load, which is the number an AI decision should be built on.
Reported use, not a prescription:
Expect fluid under the skin, higher blood pressure, a suppressed axis and the standard androgen effects on skin and hairline. Haematocrit rises as well, and that figure matters more the longer the cycle continues.
Four esters releasing at four speeds make the curve less predictable than a single-ester product, which is why users sensitive to fluctuation usually choose enanthate instead.
Oestradiol, haematocrit and lipids at baseline and week six, and again four to six weeks after the last injection. Recovery starts two to three weeks after the last shot because of the decanoate tail, and starting earlier wastes the first week.
Not for under-21s, anyone with a cardiovascular history or prostate cancer, or anyone pregnant or nursing. Store upright at room temperature, protect from light, do not freeze. Supplied for research and qualified adult use, and the laboratory testing for this range is pending rather than published.
Please log in to write Sustanon 250 review.
Four testosterone esters: propionate, phenylpropionate, isocaproate and decanoate. All of them are testosterone, released at four different speeds from one injection.
Twice a week on a cycle, to spread the propionate peak. For replacement, weekly or every ten days is enough because the decanoate carries so long.
The propionate component. It releases within a day, so the early rise is sharper than a single long ester would give, even though the eventual level is set by the total dose.
Every component is testosterone, so yes. Oestrogen follows the weekly total, which is what the AI decision should be based on.
Give it two to three weeks. The decanoate component is still releasing, so starting a SERM sooner means it works against an axis that is still being suppressed.